User guide

Software
890 USE 108 00 August 2001 55
The following table describes the DX Moves (Three Nodes), DX Matrix (Three
Nodes), and Skip Node (One Node) instructions in the Compact Instruction set.
Instruction Description
DX Moves
(Three-Nodes)
R"T Moves register values to a table
T"R Moves table values to only one register.
T"T Moves a specified set of values from one table to another table
BLKM Moves a specified block of data
TBLK Moves a block of data from a table to another specified block area
BLKT Moves a block of registers to specified locations in a table
FIN First-in operation to a queue
FOUT First-out operation from a queue
SRCH Performs a table search
IBKR Accesses data in non-contiguous registers and reads the data
into a contiguous block of registers. E984-258/265/275/285 only
IBKW Accesses data in a contiguous block of registers and writes the
data into several non-contiguous registers. E984-258/265/275/
285 only
TEST Compares signed or unsigned values between two 16-bit
registers and outputs the results based upon the relationship
E984-258/265/275/285 only
STAT Displays status registers from status table in system memory
XMWT Allows you to write to the 24K words of extended registers (6xxxx)
XMRD Allows you to read the 24K words of extended registers (6xxxx)
DIOH Retrieves health data from a specified group of drops on a
distributed I/O network