User guide

Getting Started
156
890 USE 108 00 August 2001
Downloading the
User program
The following is the procedure for downloading the user program.
Step Action Result
1 Open Project.
2 Use the menu command Online->
Download... to open the download
dialog.
3 If the PLC is in RUN mode, a prompt
will ask if you want to stop the PLC.
Confirm this query with Yes.
4 Activate the check box Configurator
(if not yet selected) to download the
configuration.
5 Activate the check box user
Program to download the user
program.
6 If you want to load initial values as
well, also activate the check box
State RAM.
7 Click at Download to load into the
PLC.
The user program and, if necessary, the
initial values are downloaded to the PLC and
the display in the footer changes to EQUAL.
8 In response to the query whether to
start the PLC, enter Yes.
The PLC will start.