User guide

Getting Started
154
890 USE 108 00 August 2001
Creating a
Project Stage 4
Using the
Concept PLC
Simulator
Stage 4 of creating a project shows how use the Concept PLC Simulator..
1 Leave Concept with File -> Exit.
2Start Concept -> SIM.
3 Activate simulation with File->
Simulation ON.
4 Leave Concept SIM with File-> Exit.
5 Start Concept again.
6 Open your project with File -> Open ...
-> Test.prjj -> OK.
Your project opens.
7 Open the Connect to PLC dialog using
Online " Connect ... .
8 Select Modbus Plus at Protocol type. IEC simulator is shown and selected.
9 Confirm with OK. Version mismatch Program "Test"
appears.
10 Confirm with OK.
11 Open the Download Controller dialog
using Online -> Download ...
12 Press button Download to load
transfer.
Program is transferred to the simulated
PLC.
13 Start Controller by pressing yes. The status RUNNING and EQUAL are
displayed at the status bar.
14 Start the animation with Online->
Animate booleans.
The current signal state of the contact
and coils are displayed (green=1, red=0).
15 To leave Concept use File -> Exit.