User guide

Getting Started
890 USE 108 00 August 2001 153
Creating a
Project Stage 3
Perform the following steps as Stage 3 of creating a project.
1 Open the FFBs from Library xxx dialog using objects -
> FFB selection.
2 Use the button Library ... to select a Library.
3 Select the Library System and confirm with OK.
4 Select the SYSCLOCK function at EFB type.
5 Leave the dialog button close. The cursor symbol
changes to a small EFB.
6 Insert the EFB at the left side of the contact.
7Use Object -> Link to activate the connect mode.
8 Place the cursor cross at the left side of the contact (till
you get the checkmark symbol).
9 Click with the left mouse button.
10 Place the cursor cross at the EFB input (till you get the
checkmark symbol).
11 Click with the left mouse button.
12 Select the coil icon at the icon bar (-O-). The cursor symbol
changes to the small coil.
13 Place the cursor cross at the CLK1 output and click with
the left mouse button.
14 Place the cursor cross at the CLK5 output and click with
the left mouse button.
15 Use Object -> Select to activate the select mode.
16 Double click at the normally closed input contact. The properties dialog
appears.
17 Select the Direct address option button.
18 Enter 100001 at the Address text box and confirm with
OK.
The address is displayed
on top of the contact.
19 Double click on the first coil.
20 Enter 000001 at the Address text box and confirm with
OK.
21 Double click on the second coil.
22 Enter 000002 at the Address text box and confirm with
OK.
23 Save the project with File-> Save project (or use
CTRL+S).