User guide

Getting Started
152
890 USE 108 00 August 2001
Creating a
Project Stage 2
Perform the following steps as Stage 2 of creating a project.
1 Select an I/O module by using the column
Module in line 1-5.
The selection dialog of all available I/
O Modules appears.
2 Select the I/O Module DAP-216-00 in
column Discrete Output.
3 Confirm this selection with the OK button. The DAP-216 type is displayed in the
Local Compact Drop dialog.
4 Enter your first output reference 000001 (Bit
output) in column Out Ref.
The last output reference of the
module is displayed automatically in
the column Out End.
5 Confirm the Local Compact Drop dialog
(OK) and the I/O Map dialog (OK).
6 Save the project which includes the
configuration and assign a name to the
project at the same time with the menu
command File -> Save project.
7 Type Test.prj at the file name text box and
confirm with OK.
8 Close the configurator window with the
control-menu box.
9 Create a new section using the menu
command File->New section...
The New Program window appears.
10 Select option button LD.
11 Type example at the Selection name and
confirm with OK
The new section appears.
12 Select the normally closed contact icon at
the icon bar (-| /|-
The cursor symbol changes to the
small contact.
13 Place the cursor near the power rail, and
click with the left mouse button in upper left
block area.
The contact will be inserted.