User guide

Getting Started
890 USE 108 00 August 2001 151
Creating a
Project Stage 1
Use the following the procedure to creating a project. in Concept. Note that the
procedure is organized into four stages. Following is stage 1.
Step Action Result
1 Start Concept.
2 Create a new project using the menu
command File->New project.
A project window without a name
(untitled) appears.
3 Open the PLC configurator with the menu
command Project -> Configurator.
The configurator window appears.
4 Select your PLC and the applicable memory
using the menu command Configure ->
PLC type...
5 Confirm this selection with the OK button. The PLC type is displayed in the PLC
selection window.
6 Open the I/O map with the menu command
Configure -> I/O map ...
The I/O map dialog window appears.
7 Open the Local/Remote, Compact I/O
dialog with the Edit button. Leave slot 1 & 2
blank because the CPU resides in slot 1+2.
If the power supply (e.g. P120-000) reside in
this slot 3, leave slot 3 blank also.
The Local/Remote, Compact I/O
dialog appears.
8 Select an I/O module by using the column
Module in line 1-4.
The selection dialog of all available I/
O Modules appears.
9 Select the I/O Module DEP 2x6/2x7 (DEP
216) in column Discrete Input.
10 Confirm this selection with the OK button. The DEP 2x6/2x7 type is displayed
in the Local Compact Drop dialog.
11 Enter your first input reference 100001 (Bit
input) in column In Ref. Use the Params ...
button to configure the various parameters
associated with the various modules.
The last input reference of the
module is displayed automatically in
the column In End.