User guide

Hardware Installation
114
890 USE 108 00 August 2001
Installing DTA Backplanes
Procedure for
Installing DTA
Backplanes
These are the DTA installation steps.
Step Action
1 Place the top clip on the back of the DTA backplane over the top of the DIN carrier
rail and drop the unit into place.
Refer to the following graphic.
2 If the DIN rail is mounted on a wall, the backplane will fall flush against the mounting
surface, as shown in (A) below. If you are using a 15 mm DIN rail, remember to insert
the mounting brace on the lower backside of the backplane before mounting it, as
shown in (B) below.
Refer to the following graphic.
1
2
Backplane
Mounting Brace
(A) (B)