Technical information

1010
Congurations.(continued)
Modicon STB distributed I/O
solution
Open and modular system
Standard Modicon STB congurations (continued)
Application-specic module for TeSys U and TeSys Quickt starter-
controllers
The STBEPI2145K parallel interface module is used to connect TeSys U
starter-controllers and TeSys Quickt motor starters.
The TeSys U starter-controller must be equipped with the LUFC00 parallel
communication module.
The characteristics and advantages of this solution are:
 Control of both directions of motor travel
 Simple wiring
 Conguration with Advantys software
 Hot swapping.possible (see page 15).
7
1
3
4
4
9
8
2
TeSys.U.connected.to.a.standard.Modicon.STB Reversing.TeSys.Quickt.connected.to.a.
standard.Modicon.STB
1
2
3
4
9
6
5
The island bus in the above examples comprises:
1 Modicon STB primary island segment.
2 STBN21: A standard NIM network interface module.
3 STBEPI2145K: Parallel interface module for TeSys U starter-controllers and
TeSys Quickt motor starters (1).
4 LU9R: Cable with one RJ45 connector at each end.
5 STBLUFC00: Modicon parallel communication module.
6 TeSys U starter-controller.
7 LAD9AP3: TeSys Quickt control connection module.
8 TeSys Quickt reversing motor starter.
9 STBXMP1100: A bus termination plate (2).
(1).Refer.to.the.“Motor-starter.solutions.Control.and.protection.components”.catalogue
(2).Supplied.with.the.NIM.network.interface.module