Technical information

106106
Combinations of Phaseo power supplies with Modicon STB modules
Type of Modicon STB module NIM network interface module
STBNpp2p1p
BOS bus expansion module
STBXBE1300K
Auxiliary power supply
STBCPS2111K
Power distribution module (PDM)
STBPDT3100K/3105K (2)
Sensors Actuators
Conguration with (1) 1 power supply ABL8RPS/RPM/WPS or
ABL4RSM/WSR (3)
3 A min. or more, depending on primary connection and consumption of the island (4)
2 power supplies ABL8RPS24030 (3 A) or
ABL4RSM24035 (3.5 A) (3)
ABL8RPS/RPM/WPS
or ABL4RSM/WSR (3)
3 A min. or more, depending on primary connection
and consumption of the island (4)
3 power supplies ABL8RPS24030 (3 A) or
ABL4RSM24035 (3.5 A) (3)
ABL8RPS24030 (3 A);
ABL8RPS24050 (5 A) or
ABL4RSM24035 (3.5 A);
ABL4RSM24050 (5 A)
(3)
ABL8RPS/RPM/WPS or
ABL4RSM/WSR (3)
3 A min. or more, depending
on primary connection and
consumption of the island (4)
If the nominal current values for Phaseo power supplies are exceeded, multiple
power supplies can be used to power NIM, BOS, CPS and PDM modules in
accordance with the rules dened above (1, 2 or 3 power supplies).
Reminder:
 The STBCPS2111K module must be used with an STBPDT3100K/3105K power
distribution module.
 24 V  power supplies. The input currents of these power supplies are as
follows:
 NIM network interface module STBN: 0.4 A
 BOS bus expansion module STBXBE1300K: 0.3 A
 Auxiliary power supply STBCPS2111K: 0.3 A
 Power distribution modules (PDM): the maximum current is as follows:
 STBPDT3100K for sensor power supply: 4 A at 30°C, 2.5 A at 60°C
 STBPDT3100K for actuator power supply: 8 A at 30°C, 5 A at 60°C
 STBPDT3105K for sensor/actuator power supply: 4 A at 30°C, 2.5 A at 60°C
(1).See.diagrams.below
(2).Basic.power.distribution.module.STBPDT3105K:.installation.with.1.or.2.power.supplies.only
(3).Certain.offers.can.not.be.marketed.in.certain.countries,.please.consult.our.Customer.Care.
Center
(4).Consumption.statistics.for.the.5.V.logic.power.supply.and.24.V.sensor.and.actuator.power.
supplies.can.be.viewed.using.the.Advantys.STBSPU1pppp.conguration.and.debugging.
software.Consumption.statistics.for.the.5.V.logic.power.supply.can.be.produced.manually.
using.the.table.on.page.114
IN
OUT
IN
OUT
115/230 V 115/230 V
24 V

3 3
IN/OUT IN/OUT
Conguration.with.basic.PDM.and.two.separate.24.V.
power.supplies
IN
OUT
IN
OUT
115/230 V
115/230 V
24 V
3
3
IN/OUT
IN/OUT
Conguration.with.basic.PDM.and.one.24.V.power.supply.
Conguration.with.standard.PDM.and.three.separate.24.V..
power.supplies
115/230 V 115/230 V
115/230 V

24 V

IN
OUT
IN
OUT
1 1
2
2
Compatibility
Modicon STB distributed I/O
solution 0
Phaseo regulated switch mode power supplies