User manual

Installation and Configuration
354
33002479 06 07/2008
Overview
Introduction This quick start guide explains how to install and configure Modicon Quantum
Ethernet modules and set up a I/O scanning communication service. The following
types of modules are applicable to this guide:
z 140 NOE 771 01
z 140 NOE 771 11
z 140 CPU 651 50
z 140 CPU 651 60
Hardware/
Software
Requirements
For the example discussed in this guide, the following Modicon Quantum Ethernet
modules are required:
z 140 CPS 114 x0 power supply
z 140 CPU 651 50 CPU
z 140 NOE 77101 communication module
Also, a PC running Windows 2000 or XP with Schneider’s Unity Pro configuration
software installed on it is required.
Finally, either a USB or a Modbus cable is required to connect the PC to the network
PLC.
Intended
Audience
This user guide is intended for anyone who is involved in installing and configuring
Modicon Quantum Ethernet modules in a network arrangement that can perform a
variety of communication services.
Anyone reading this guide should:
z be familiar with Ethernet networks and the TCP/IP protocol
z understand the operation of PLCs