User manual

Global Data (Publish/ Subscribe)
33002479 06 07/2008 197
Configuring the
NOE
Uploading a
glbdat.ini File to
a PC
Step Action
1 Select one NOE.
2 Using your browser, navigate to that NOE’s Global Data Configuration page.
Follow these links: | Setup | Global Data |
3 Enter the configuration’s variable IDs, symbols (description), and lengths.
4 Click the Update Global Data Configuration button to update the file. This creates
the file glbdata.ini.
Full path follows:
ftp://NOE_IP_ADDRESS/wwwroot/conf/glbdata/glbdata.ini
Note: You substitute NOE_IP_ADDRESS with an address like 192.168.000.010.
Please check the address with your system administrator.
5 Using the FTP process, upload the glbdata.ini file to a PC. (See the information
below at Uploading a glbdata.ini file.)
6 Stop each controller before you do the customization.
7 Using the same path, download the glbdata.ini file to the other devices. (See the
information below at Downloading a glbdata.ini file.)
8 Connect your Web browser to each device to customize start address and the
Publish/Subscribe setting.
Note: The Global Data Configuration page is populated with data from the
glbdata.ini configuration file.
Step Action
1 At the DOS prompt type FTP followed by the IP address and press Enter.
2 At the User prompt type FTP Username and press Enter.
3 At the password prompt enter your FTP Password and press Enter.
4 At the FTP prompt type cd wwwroot/conf/glbdata and press Enter.
5 At the FTP prompt type get and press Enter.
6 At the local file prompt type glbdata.ini and press Enter.
7 At the remote file prompt type glbdata.ini and press Enter.