Hardware reference guide

CableFast Cabling
35013379 02 October 2007 857
Note:
1. When used with the 140AVO02000 analog voltage out module, the master
override connections and range select must be made on the Quantum I/O
connector.
2. When using a single power supply, there will be no channel-to-channel isolation
of input points.
3. For the required jumper options for the 140ACO02000 and the AVO02000, see
wiring diagrams in 140ACO02000 Quantum I/O Analog Current Out Module,
p. 550 and the 140AVO02000 Quantum I/O Analog Voltage Out Module, p. 558.
4. The GND (ground) terminal point is not connected.
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com