Hardware reference guide

Hardware Installation
774
35013379 02 October 2007
Removing a
Quantum Module
Door
The Quantum Automation Series module terminal strips have been designed with a
flexible, removable door to allow for easier wiring and access to the terminal strip.
Follow the procedure below to remove the module door.
140
DDO84300
10-80 VDC OUT
1
Open the module door.
2
Place your thumb near the middle
of the door (as illustrated).
3
With your thumb, apply pressure
until the door bends and the door
hinge pins pop out of the retaining
holes at the top and bottom of the
terminal strip.
4
After wiring the module, reinstall the
door using the reverse of the above
procedure.
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com