Hardware reference guide

Hardware Installation
35013379 02 October 2007 773
Removing a
Quantum I/O
Terminal Strip
The Quantum Automation Series I/O terminal strips have been designed with a pry
slot to assist in their removal. Follow the procedure below to remove the terminal
strip.
140
DDO84300
10-80 Vdc Out
Pry Slot
(Insert screwdriver)
(Exploded View)
Mounting Screws
2
1
1
Loosen the terminal strip mounting
screws located at the top and
bottom of the terminal strip.
2
Located the pry slot at the top of the
terminal strip near the top
mounting screw.
3
From the front and at an angle,
insert a flat edge screwdriver into
the pry slot and lever the top of the
terminal strip away from the
module.
4
Once the top of the terminal strip
has been loosened, the terminal
strip may be completely removed
by continuous outward pressure
with the screwdriver.
5
To reinstall the terminal strip into
the module, follow the procedure
previously described.
3
4
Pry Slot
Backplane
Module
(Side view)
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com