Hardware reference guide

Hardware Installation
772
35013379 02 October 2007
Installing Module
Terminal Strip
Jumper Clips
Terminal strip jumper clips (see below) are installed when contiguous I/O points
need to be jumpered (i.e., the AVO 020 00 Analog Voltage Out module). Follow the
procedure below for installing jumper clips.
3
Insert
Jumper Clip
Terminal Strip
I/O Screw
140
AVO 020 00
ANALOG VOLTAGE OUT
Inserted Jumper Clip
Exploded view of an inserted jumper clip
4
5
1
2
3
4
Turn power off to the system.
Remove the terminal strip from the
module (see next page).
Loosen the terminal strip I/O screws of
the points that you want jumpered.
Insert the jumper clip under the loosened
screws (see exploded view below).
Tighten the screws and reinstall the
module (see previous page).
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com