Hardware reference guide

Power Supplies
76
35013379 02 October 2007
Specifications The following table shows the specifications for the CPS11100 115/230 VAC power
supply module (PV01 or greater).
Specifications
Input Requirements
Input Voltage 100 ... 276 Vac
Input Frequency 47 ... 63 Hz
Input Voltage Total Harmonic
Distortion
Less than 10% of the fundamental ms value
Input Current 0.4 A @ 115 Vac. 0.2 A @ 230 Vac
Inrush Current 10 A @ 115 Vac. 20 A @ 230 Vac
VA Rating 50 VA
Input Power Interruption 1/2 cycle @ full load and minimum rated line voltage /
frequency. No less than 1 second between interruptions.
Fusing (external) 1.5 A slo-blo recommended (Part # 043502515 or
equivalent)
Output to Bus
Voltage 5.1 Vdc
Maximum Current 3 A
Minimum Current 0.3 A
Protection Over Current, Over Voltage
General
Field Wiring Connector
(included)
7 point terminal strip (Part # 043506326)
Internal Power Dissipation 2.0 + 3.0 x I
OUT
= Watts (where I
OUT
is in Amperes)
Operating Mode Standalone
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com