Hardware reference guide

I/O Modules

730

35013379 02 October 2007

Fuse Locations The following figure shows the fuse locations of the DDM39000 module.

Possible injury to personnel or equipment.

Turn off power to the module and remove the field wiring terminal strip to gain

access to fuses.

Failure to follow these instructions can result in injury or equipment damage.

CAUTION

Note: If the 140DDM39000 module is used in an RIO drop, the 140CRA93X00 RIO

Drop must be Version 1.04 at a minimum. Check the version label, (see Version

Label, p. 731)) on the top front of the 140CRA93X00 module and ensure that it is

at the proper revision level. Any module marked PV/RL/SV is acceptable.

140

DDM 390 00

10 80 VDC OUT

Fuse Locations

Points

1-4

Points

5-8

This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com