Hardware reference guide

Power Supplies
35013379 02 October 2007 73
Specifications The following table shows the specifications for the CPS11100 115/230 VAC power
supply module.
Specifications
Input Requirements
Input Voltage 93 ... 132 Vac (jumper installed)
170 ... 264 Vac (no jumper)
Input Frequency 47 ... 63 Hz
Input Voltage Total Harmonic
Distortion
Less than 10% of the fundamental ms value
Input Current 0.4 A @ 115 Vac. 0.2 A @ 230 Vac
Inrush Current 13 A @ 115 Vac. @ 25°C first power up
23 A @ 230 Vac. @ 25°C first power up
VA Rating 50 VA
Input Power Interruption 1/2 cycle @ full load and minimum rated line voltage /
frequency. No less than 1 second between interruptions.
Fusing (external) 1.5 A slo-blo recommended
(Part # 043502515 or equivalent)
Output to Bus
Voltage 5.1 Vdc
Maximum Current 3 A
Minimum Current None required
Protection Over Current, Over Voltage
General
Field Wiring Connector
(included)
7 point terminal strip (Part # 043506326)
Internal Power Dissipation 6 Watts typ.
Operating Mode Standalone
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com