Hardware reference guide

I/O Modules
35013379 02 October 2007 707
Tungsten Load Maximum 2.5 W @ 10 Vdc
3 W @ 12 Vdc
6 W @ 24 Vdc
Load Capacitance Maximum 75 μf
Isolation
Group to Bus 1780 Vac RMS for 1 minute
Group to Group 500 Vac for 1 minute
Output Protection (internal) Transient voltage suppression, overload (short circuit)
protection
Fault Detection Blown fuse detect, loss of power, incorrect output state
Bus Current Required 500 mA
Power Dissipation [2.5 + (0.1 x No. of points ON) + (total load current x 0.4)]
watts
External Power 10 ... 30 Vdc
Fusing
Internal
External
5.0 Amp fuse per group, P/N 0043502405
Not required. If desired, a 3/4 A, 250 V fuse
(P/N 57-0078-00) may be used
Programming Software
Type and version Concept, Version 2.2 or higher
Modsoft, Version 2.6.1 or higher
Specifications
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com