Hardware reference guide

I/O Modules
35013379 02 October 2007 635
I/O Map Status
Byte (Outputs)
The least significant bit in the output I/O map status byte is used as follows. The
following figure shows the status byte output register.
Modsoft Module
Zoom Selections
(Outputs)
Push <Enter> to display and select the output type and the timeout state for the
module. Timeout state is assumed when system control of the module is stopped.
The following figure shows the output type and timeout state.
16-Point Output
Modules
The 16-point output modules are as follows:
z 140DAO84000 (AC Output 24 ... 230 Vac 16x1)
z 140DAO84010 (AC Output 24 ... 115 Vac 16x1)
z 140DAO84210 (AC Output 100 ... 230 Vac 4x4)
z 140DAO84220 (AC Output 48 Vac 4x4)
z 140DDO84300 (DC Output 10 ... 60 VDC 2x8 Source)
z 140DRA84000 (Relay Output 16x1 Normally Open)
I/O Map Register
Assignment
The output modules listed above can be configured as either 16 contiguous discrete
output (0x) references, or as one output (4x) register in the following formats. The
following figures show the formats for the output modules.
Module Fault
(any point fault turns on this bit)
12345678
Note: To clear a fault, the point must be commanded OFF in user logic.
BIN
BCD
Last Value
User Defined
Timeout State:
Output Type:
User Defined Timeout State Points 1-12: 000000000000
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com