Hardware reference guide

I/O Modules
35013379 02 October 2007 531
Note:
1. The current sources are supplied by the user (fusing is at the discretion of the
user.)
2. Either shielded or unshielded cables may be used. In noisy environments,
twisted shielded cable is recommended. Shielded cable should have a shield
tied to earth ground near the signal source end.
3. Unused inputs may cause the activation of the F LED. To avoid this occurrence
the unused channels should be configured in the 0 ... 25 mA range.
4. The maximum channel to channel working voltage cannot exceed 30 Vdc.
5. N/C = Not connected
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com