Hardware reference guide

I/O Modules
35013379 02 October 2007 527
Note:
1. The current and voltage sources are supplied by the user (fusing is at the
discretion of the user).
2. Either a shielded or unshielded signal cable may be used. Shielded types
should have a shield tied to earth ground near the signal source end.
3. Unused inputs may cause the activation of the F LED. To avoid this occurrence,
wire unused channels in voltage mode to a channel that is in use.
4. N / C = Not connected.
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com