Hardware reference guide

Battery Module
488
35013379 02 October 2007
Installing/
Removing a
Battery
The following procedure describes how to install or remove a battery.
Step Action
1 Remove the insulating strip from the new battery.
2 If necessary, remove the old battery. Detach it from its housing (on the front of
the module), by pulling the battery access strip (see below) until the battery pops
out.
3 Replace it with the new battery using the reverse of the procedure in step 2.
Insulating Strip
Battery
Pull on this tape to
remove battery. Do
not use metallic tool.
CAUTION
Access Strip
Batt. install date
MAY CAUSE PERSONAL INJURY OR DAMAGE TO EQUIPMENT
Do not use any metallic tools (i.e., pliers, screwdriver, etc.) when removing or replacing
a battery in this module. Using tools during removal and replacement may cause per-
sonal injury and/or damage to the battery and this module.
Failure to follow this instruction
can result in death, serious injury, or equip-
ment
damage.
WARNING
MAY CAUSE PERSONAL INJURY OR DAMAGE TO EQUIPMENT
Ensure that proper polarity is maintained when connecting and inserting new batteries
into the XCP90000. Inserting the battery improperly may cause personal injury and/or
damage to this module.
Failure to follow this instruction
can result in death, serious injury, or equip-
ment
damage.
WARNING
HAZARDOUS WASTE
Used batteries (hazardous waste) must be disposed of according to local rules and
regulations governing hazardous waste.
Failure to follow this instruction can result in injury or equipment damage.
CAUTION
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com