Hardware reference guide

Modbus Plus NOM
296
35013379 02 October 2007
Setting the slide switch to the bottom position gives you the ability to assign comm
parameters to the port in software. The following parameters are valid.
Stop Bits 1
Device Address Rear panel rotary switch setting
Valid Mem Comm Port Parameters
Baud 19,200 1,200
9,600 600
7,200 300
4,800 150
3,600 134.5
2,400 110
2,000 75
1,800 50
Data Bits 7 / 8
Stop Bits 1 / 2
Parity Enable/Disable Odd/Even
Device Address Rear panel rotary switch setting
RTU Comm Port Parameters
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com