Datasheet

82
16
Installation and Adjustment Guidelines for MINIRAIL and MINISCALE PLUS
Relubrication intervals
The relubrication interval depends onmany variables, e.g. load, working environ-
ment, speed, etc. and therefore cannot be calculated. The lubrication point must
therefore be observed over a longer period of time.
A) Relubrication with oil
A relubrication set with KLÜBER Structovis GHD can be ordered from
SCHNEEBERGER, part numberMNW.
The two lubrication holes in the front plates allow the ball recirculation pathways to
be lubricated with oil directly (see chapter 7.1.8). Ensure both tracks are properly
lubricated.
During lubrication, the carriages should be moved along the entire length of the rail
so that the lubricant isapplied to boththe carriage and guideway.
B) Relubrication with grease
The tracks of the guideway should be coated in a thin film of grease using a lint-free
cloth. The carriages should then be moved along the entire length of the rail so that
the lubricant is applied to the ball bearings and distributed along the guideway.
16.3.4 Lubrication of MINISCALE PLUS
Please refer to the installation instructions in the downloadsection of
www.schneeberger.com
Relubrication set (MNW), contents 7 ml