Datasheet

60
13
MINISLIDE Frictionless Table Product Overview
13.3.3 Reference and Supporting Surfaces
The locating and supporting surfaces of carriages and guideways are designated
as follows.
MS type MSQ type
Carriage locating and supporting surfaces
Guideway locating and supporting surfaces
The reference side of the carriage is opposite the carriage side with the company
logo / type designation. The guideway can be located on both sides.
13.3.4 Running Accuracy and Parallelism of Supporting Surfaces
The tolerance for the straightness of the stroke depends on the length of the
guideway.
The following table shows the corresponding maximum values.
The measurements are taken in an unloaded state on a flat surface.
System length L Straightness of the stroke
horizontally and vertically
10 – 30 mm 3 μm
40 – 80 mm 4 μm
90 – 130 mm 5 μm
System length L Parallelism of the supporting surfaces
(frictionless table in the center position)
10 – 30 mm 12 μm
40 – 80 mm 15 μm
90 – 130 mm 18 μm