Technical information

Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
Watson SHDSL Router
Web-based Management Manual
Revision: 2012-02-29
8-15
such as a security server, requires that packets have a specific IP address – you
can define a NAT rule for that address.
8.2.7.1 Configuration
Click the 'NAT' tab in the 'Security' management screen. The 'NAT' screen will ap-
pear .
Figure 8-17: Network Address Translation
Before configuring NAT/NAPT rules, you must first enter the additional public IP
addresses obtained from your ISP as your NAT IP addresses, in the 'NAT IP Ad-
dresses Pool' section. The primary IP address used by the WAN device for dynam-
ic NAPT should not be added to this table. To add a NAT IP address, click the 'New
IP Address' link. The 'Edit Item' screen will appear.
Figure 8-18: Edit Item