Technical information

Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
Watson SHDSL Router
Web-based Management Manual
Revision: 2012-02-29
9-65
interface (see Chapter 9.4.11). After reconnection the LAN Switch Ports appears in
the Stacked VLAN mode table. For each LAN Switch Port the default provider S-
VLAN ID and S-VLAN Priority can be defined.
The ‘VID’ defines the default VLAN ID of the outer tag (Service Provider tag) which
will be added to frames ingressing the selected LAN Switch Port.
The ‘VPrio’ defines the default VLAN Priority of the outer tag (Service Provider tag)
which will be added to frames ingressing the selected LAN Switch Port.
9.4.10.8 Advanced
Internet Connection Firewall Your gateway's firewall helps protect your com-
puter by preventing unauthorized users from gaining access to it through a network
such as the Internet. The firewall can be activated per network connection. To ena-
ble the firewall on this network connection, select the 'Enabled' check box. To learn
more about your gateway's security features, refer to Section 8.2.
Figure 9-97: Internet Connection Firewall
Additional IP Addresses You can add alias names (additional IP ad-
dresses) to the gateway by clicking the 'New IP Address' link. This enables you to
access the gateway using these aliases in addition to the 192.168.1.1.
Figure 9-98: Additional IP Addresses
9.4.11 Virtual LAN Interface (VLAN)
Watson allows you to create Virtual LAN (VLAN) interfaces in order to connect to
external virtual networks.
To configure the Ethernet Switch for VLAN operation refer to section Error! Refer-
ence source not found..
9.4.11.1 Creation with the Connection Wizard
To create a new VLAN interface, perform the following steps:
In the 'Network Connections' screen (see Figure 9-11), click the 'New Connection'
link. The 'Connection Wizard' screen appears (see Figure 9-12).
Select the 'Advanced Connection' radio button and click 'Next'. The 'Advanced
Connection' screen appears (see Figure 9-15).