Technical information

Watson SHDSL Router
Web-based Management Manual
Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
9-28
Revision: 2012-02-29
Click the 'New IP Address' link. The 'DHCP Relay Server Address' screen will
appear:
Figure 9-39: DHCP Relay Server Address
Specify the IP address of the DHCP server.
Click 'OK' to save the settings.
 Disabled - Select 'Disabled' from the combo-box if you would like to statically
assign IP addresses to your network computers.
Figure 9-40: IP Address Distribution - Disable DHCP
9.4.4.3 Routing
You can choose to setup your gateway to use static or dynamic routing. Dynamic
routing automatically adjusts how packets travel on the network, whereas static
routing specifies a fixed routing path to neighboring destinations.
Routing Mode Select one of the following routing modes:
 Route Use route mode if you want your gateway to function as a router be-
tween two networks.
 NAPT Network Address and Port Translation (NAPT) refers to network ad-
dress translation involving the mapping of port numbers, allowing multiple ma-
chines to share a single IP address. Use NAPT if your LAN encompasses mul-
tiple devices, a topology that necessitates port translation in addition to address
translation.
Device Metric The device metric is a value used by the gateway to determine
whether one route is superior to another, considering parameters such as band-
width, delay, and more.
Default Route Select this check box to define this device as a the default
route.
Routing Information Protocol (RIP) Select this check box to enable the
Routing Information Protocol (RIP). RIP determines a route based on the smallest
hop count between source and destination. When RIP is enabled, select the follow-
ing:
 Listen to RIP messages—select 'None', 'RIPv1', 'RIPv2' or 'RIPv1/2'.