Technical information

Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
Watson SHDSL Router
Web-based Management Manual
Revision: 2012-02-29
9-23
Routing Information Protocol (RIP) Select this check box to enable the
Routing Information Protocol (RIP). RIP determines a route based on the smallest
hop count between source and destination. When RIP is enabled, select the follow-
ing:
 Listen to RIP messages—select 'None', 'RIPv1', 'RIPv2' or 'RIPv1/2'.
 Send RIP messages—select 'None', 'RIPv1', 'RIPv2-broadcast' or 'RIPv2-
multicast'.
Routing Table Allows you to add or modify routes when this device is active.
Use the 'New Route' button to add a route or edit existing routes.
Figure 9-27: Advanced Routing Properties
To learn more about this feature, refer to Section 9.6.1.
9.4.3.4 Advanced
Internet Connection Firewall Your gateway's firewall helps protect your com-
puter by preventing unauthorized users from gaining access to it through a network
such as the Internet. The firewall can be activated per network connection. To ena-
ble the firewall on this network connection, select the 'Enabled' check box. To learn
more about your gateway's security features, refer to Section 8.2.
Figure 9-28: Internet Connection Firewall
Additional IP Addresses You can add alias names (additional IP ad-
dresses) to the gateway by clicking the 'New IP Address' link. This enables you to
access the gateway using these aliases in addition to the 192.168.1.1 .
Figure 9-29: Additional IP Addresses