Technical information

Watson SHDSL Router
Web-based Management Manual
Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
9-18
Revision: 2012-02-29
9.4.3.1 General
To view and edit the WAN Ethernet connection settings, click the 'WAN Ethernet'
link in the 'Network Connections' screen (see Figure 9-11). The 'WAN Ethernet
Properties' screen will appear, displaying a detailed summary of the connection's
parameters, under the 'General' tab. These parameters can be edited in the rest of
the screen's tabs, as described in the following sections.
Figure 9-16: WAN Ethernet Properties – General
9.4.3.2 Settings
This section displays the connection's general parameters. It is recommended not
to change the default values unless familiar with the networking concepts they rep-
resent. Since your gateway is configured to operate with the default values, no pa-
rameter modification is necessary.
Figure 9-17: WAN Ethernet Properties - Settings
Status The connection status should always show ‗Connected‘, because the
WAN Ethernet interface is always connected to the inernal DSL modem.
Schedule By default, the connection will always be active. However, you can
configure scheduler rules in order to define time segments during which the con-