Technical information

Watson SHDSL Router
Web-based Management Manual
Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
8-90
Revision: 2012-02-29
Perform the same procedure on Gateway B with its respective parameters. When
done, the IPSec connection's status should change to "Connected".
8.4.2 Point-to-Point Tunneling Protocol Server
Watson can act as a Point-to-Point Tunneling Protocol Server (PPTP Server), ac-
cepting PPTP client connection requests.
8.4.2.1 Configuring the PPTP Server
Access this feature either from its link in the 'VPN' tab under the 'Services' screen,
or by clicking the 'PPTP Server' icon in the 'Advanced' screen. The 'Point-to-Point
Tunneling Protocol Server (PPTP Server)' screen appears:
Figure 8-113: Point-to-Point Tunneling Protocol Server (PPTP Server)
This screen enables you to configure:
Enabled Check or un-check this box to enable or disable this feature.
Note that checking this box creates a PPTP server (if not yet created with the wiz-
ard), but does not define remote users.
Click Here to Create VPN Users Click this link to define remote users that will be
granted access to your home network. Refer to Section 9.3 to learn how to define
and configure users.
Remote Address Range Use the 'Start IP Address' and 'End IP Address' fields
to specify the range of IP addresses that will be granted by the PPTP server to the
PPTP client.