Technical information

Watson-SHDSL-Router-GUI-Manual.doc
Version 2.3-03
Watson SHDSL Router
Web-based Management Manual
Revision: 2012-02-29
8-77
6. Assigning the New IPSec Policy: In the 'Local Security Settings' window, right-
click the 'Watson Connection' policy, and select 'Assign'. A small green arrow
will appear on the policy's folder icon and its status under the 'Policy Assigned'
column will change to 'Yes'.
Figure 8-93: Local Security Settings
8.4.1.5 IPSec Gateway-to-Gateway Connection Scenario
This section describes how to configure an IPSec gateway to gateway with a pre-
shared secret scenario, developed by the VPN Consortium (VPNC) using Watson.
8.4.1.5.1 Network Configuration
Establishing an IPSec tunnel between Gateways A and B creates a transparent and
secure network for clients from subnets A and B, who can communicate with each
other as if they were inside the same network.The following scenario depicts such a
connection between two Watson gateways. The configurations of both gateways
are identical, except for their IP addresses. This section describes the configuration
of Gateway A only. The same configuration must be performed on Gateway B, with
the exceptions that appear in the note admonitions.
Figure 8-94: Configuration Diagram