Specifications

Watson-TDM-Manual-W.doc
Version 2.0-01
Watson TDM
Operating Manual
Revision: 2008-02-07 8-17
If used with the Regenerator then the STATUS display is
REG_01_FMM_REMOTE> STATUS
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local System Status V2.0
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
SYNC-RA: 02 OPS-RA: 01 PID-RA: 01 PWR-RA: +13.50
SYNC-RB: 02 OPS-RB: 01 PID-RB: 02 PWR-RB: +13.50
SYNC-CA: 02 OPS-CA: 01 PID-CA: 01 PWR-CA: +13.50
SYNC-CB: 02 OPS-CB: 01 PID-CB: 02 PWR-CB: +13.50
SYNC
Status of SHDSL synchronization according to ETSI TS 101 524.
00 Out of Sync State
01 State 0
02 In Sync State
03 State 1
04 State 2
05 State 3
06 State 4
07 State 5
OPS
Operational mode of the transceiver
00 Idle Mode
01 Data Mode
10 Startup handshake in progress
18 Startup training in progress
80 Local analog loopback
PID
Pair Identification when 4p operation is enabled
PWR
Transmit power of each channel [dBm]
RPV-A
RPV-B
Remote Power Voltage of loop A and B (in Volts)
Note:
To display regenerator status you have to log on to the remote monitor terminal
of a Regenerator with the CONNECT command.