Specifications

Watson TDM
Operating Manual
Watson-TDM-Manual-W.doc
Version 2.0-01
8-8
Revision: 2008-02-07
MODE number-of-pairs
MODE 1: 1 pair operation
MODE 2: 2 pair operation
MODE 3: 3 pair operation
MODE 4: 4 pair operation
See 3.1.3.
Note
MODE causes a restart of the DSL link
POWER ON | OFF
Set DSL remote powering ON / OFF.
RESTART ON | OFF
Set DSL autorestart ON / OFF.
WETTING ON | OFF
Enables (ON) or disables (OFF) sinking of wetting current. Only available on table-
top modems.
8.2.4 User Interface Configuration
ACTLED ON | OFF
Turns user interface activity on (ACTLED ON) or off (ACTLED OFF). If turned on
then activity on the user interface will be shown on the LED "2" (LED "Remote")
on the tabletop modem. The Activity LED blinks if at least one signal transition
has been detected within one second on Tx or Rx.
If activity is detected on Tx (user data towards DSL) then the LED is blinking
green. If activity is detected on Rx (user data from DSL) the LED will blink amber.
If activity is detected on both Tx Data and Rx Data, the LED will blink alternating
green/amber.
User interface activity indication is available on modems with a nx64 user inter-
face and on modems with an E1 user interface and if the interface is operated in
G.703 transparent/unframed mode. In case of multiservice operation, only activity
of the nx64 user interface is indicated, while activity on the E1 interface is not
monitored.
Invoking a DEFAULT command will disable user interface activity indication.
Note:
User interface activity indication is only available if the unit is configured as
Slave.