Specifications

Watson-TDM-Manual-W.doc
Version 2.0-01
Watson TDM
Operating Manual
Revision: 2008-02-07 8-5
For tabletop modems the following parameters are modified with the DEFAULT
command:
Parameter
DEFAULT 0 DEFAULT 1 DEFAULT 2
SHDSL
Master/Slave Slave Slave Slave
Autorestart Enabled Enabled Enabled
Power Backoff Disabled Disabled Disabled
Payload Rate Determined by
master
Determined by mas-
ter
Determined by mas-
ter
Operating Mode 1 Pair Determined by mas-
ter
Determined by mas-
ter
Line Rate Determined by
master
Determined by mas-
ter
Determined by mas-
ter
Wetting Current Off Off Off
2 MBit/s
Framing Transparent ITU-T G.704 Transparent
CRC4 -- On --
E-Bit Insertion -- On --
AIS Generation On On On
AIS Detection On On Off
Clock Mode Local 2 Mbps port Local 2 Mbps port Local 2 Mbps port
Data Rate 32 x 64 = 2048
kbit/s
31 x 64 = 1984 kbit/s 32 x 64 = 2048 kbit/s
TS Mapping
Mode
-- 1 --
n x 64
Bitrate Off Off Off
Clock Mode Remote Remote Remote
Clock Direction Codirectional Codirectional Codirectional
V.54 Loops Disabled Disabled Disabled
Handshake Disabled Disabled Disabled
LEDs
User Interface
Activity indica-
tion
Off Off Off
Table 8-3: DEFAULT values for Watson TDM tabletop modems
Note
The factory setting can be loaded using the DEFAULT 2 command. All modems
are delivered with this configuration.