Specifications

Watson-TDM-Manual-W.doc
Version 2.0-01
Watson TDM
Operating Manual
Revision: 2008-02-07 8-3
CONFIG
The CONFIG command displays the current configuration of the modem:
LTU_01_CM>CONFIG
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local Configuration Id : 2 MBit/s G.703
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
2 MBit/s
Framing : ITU-T G.704
CRC4 : On
E-Bit Insertion : On
AIS Generation : On
AIS Detection : On
Clock Mode : Local 2Mbit Port
Data Rate : 01 x 64 = 00064 kbit/s
TS Mapping Mode : 2
SHDSL
Master/Slave : Master
Autorestart : Enabled
Power Backoff : Disabled
Payload Rate : 00192 kbit/s
Operating Mode : 1 Pair
Line Rate : 00208 kbit/s
Remote Powering : On
Regenerators : --
TMN
Address : 01
V.11 wires : 02
Management
Admin Name : ZRHBINZ35
Notes:
• After each configuration change, the new configuration is automatically dis-
played.
• If the DSL clock mode is set to "Network reference" (LTUMODE N) then the
this is shown in the Operating Mode line
• For tabletop modems the wetting current status (wetting current sink on/off)
is shown instead of the Remote Powering status
When both an nx64 kbit/s and an E1 interface are equipped, the configuration
display shows first the E1/PRA configuration and then the nx64 kbit/s configura-
tion, e.g.:
LTU_01_CM>CONFIG
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local Configuration Id : Multiservice
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
2 MBit/s
Framing : ITU-T G.704
CRC4 : Off
E-Bit Insertion : --
AIS Generation : On
AIS Detection : Off
Data Rate : 11 x 64 = 00704 kbit/s
X.21
Bitrate : 20 x 64 = 01280 kbit/s
Clock Mode : Remote
Clock Polarity : Normal
Byte Timing : Off
Handshake : Disabled
SHDSL
Master/Slave : Slave
Autorestart : Enabled
Power Backoff : Disabled
Payload Rate : 02048 kbit/s
Operating Mode : 1 Pair
Line Rate : 02056 kbit/s