Specifications

Watson TDM
Operating Manual
Watson-TDM-Manual-W.doc
Version 2.0-01
8-2
Revision: 2008-02-07
8.2 Configuration Management CM
The commands available in the configuration management menu vary depending
on modem hardware, firmware and current configuration. Example:
LTU_01_CM> H
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
CONFIG Display local configuration
G704 [ON,OFF] Set framed mode / transparent mode
CRC4 [ON,OFF] Set CRC4 mode on/off
EBIT [ON,OFF] Set automatic E-Bit insertion on/off
AISGEN [ON,OFF,T] Set AIS generation on/off/transparent
AISDET [ON,OFF] Set AIS detection on/off
CLK2M [EXT,INT,E1] Select 2Mbit reference clock:
external/internal/2Mbit Port
MP Display E1 time slot map
MP [0..5] Set E1 time slot mapping mode
MASTER [ON,OFF] Set SHDSL master mode / slave mode
POWER [ON,OFF] Set remote powering on/off
RESTART [ON,OFF] Set autorestart on/off
BACKOFF [ON,OFF] Set power backoff on/off
LINERATE n i Select line rate (n=[3..89] i=[0,1])
MODE [1,2] Set SHDSL operating mode (number of pairs)
LTUMODE [mode] Select basic LTU operating mode:
1: 4x1p L: Local Oscillator
2: 2x2p (UIF 1&2) N: Network Reference
3: 1x2p + 2x1p
4: 1x4p
5: Multipoint
6: 2x2p (UIF 1&3)
8: 2x2p (UIF 3&4)
12: 1x3p + 1x1p
14: 2xE1 on 1p
15: 3xE1 on 2p
16: 4xE1 on 3p
GROUP Display available 1+1 protection groups
GROUPn [ON,OFF] Enable / disable 1+1 protection group
ADDRESS slot rack Set TMN address (slot=[1..12] rack=[0..1])
V11WIRES [2,4] Set number of V.11 wires
ADMIN-NAME [name] Set / display this system's administrative name
DEFAULT [0..2] Set default configuration
MAIN (M) Return to main menu
8.2.1 General Commands
ADMIN-NAME [ String ]
Sets an administrative name for the subsystem. The administrative name of the
subsystem is displayed in the Monitor welcome screen and in the CONFIG
screen. Use quotes ("") to enter an upper/lowercase administrative name.
ADMIN-NAME without parameter will display the administrative name.