Installation guide

SZ-DOC-W5-1.pdf LTU/NTU
Version: 1.5 Operating Manual
73 Revision: 2002-09-10
Circuit 107 (DSR) and 109 (RLSD) are set into status ON when a SHDSL link is established.
Circuit 106 (CTS) is set to status ON only when link is established
AND circuit 105 (RTS) is in ON state.
HANDSHAKE OFF:
Circuit 106 (CTS), 107 (DSR) and 109 (RLSD) are set into status ON when a SHDSL link is
established.
Status of circuit 108 (DTR) is detected and displayed by DTR-S alarm in both cases
B.) User interface type X.21
HANDSHAKE ON:
Circuit I is set to status ON only when circuit C is in ON state.
Interruption of SHDSL link has no influence on status of I.
HANDSHAKE OFF:
Circuit I is set permanently to status ON independent of circuit C state.
7.4.2.9 UIF Command
Select the interface type: V35 = V.35, V36 = V.36, X21 = X.21.
When both an nx64 kbit/s and an E1 interface are equipped, also the values E1 and PRA are
possible to switch between E1 and PRA mode.
7.4.2.10 DEFAULT Command
The DEFAULT command sets a default configuration.
When both an nx64 kbit/s and an E1 interface are equipped, a default configuration is set for
both interfaces.
Three default settings are available for the nx64 kbit/s interface:
NTU_CM> DEFAULT 0
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local Configuration Id : nx64 kbit/s V.35
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
V.35
Bit Rate : 32 x 64 = 02048 kbit/s
Clock Mode : Remote
Clock Direction : Codirectional
V.54 Loops : Disabled
Handshake : Disabled
SHDSL
Master/Slave : Slave
Autorestart : Enabled
Power Backoff : Disabled
Payload Rate : 02048 kbit/s
Operating Mode : 1 Pair
Line Rate : 02056 kbit/s
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NTU_CM>