Specifications

Watson 5 Ethernet
Operating Manual
W5-Ethernet-Manual.doc
Version 2.0-01
7-24 Revision: 2006-04-27
RESETG826 DSL-Port
The RESETG826 command sets the G.826 values for a DSL port. On the Watson 5 Ethernet ta-
bletop it is not required to specify a port.
LTU_01_PM> RESETG826 DSL1
G.826 error performance parameter reset for DSL1
7.3.2 Ethernet Statistics
ETHERNET Port [ C ]
The ETHERNET command displays Ethernet statistics. It may be abbreviated to ETH.
ETHERNET Port C updates the display continuously. For Port any of the external or inter-
nal Ethernet ports may be specified: ETH1 .. ETH4, DSL1 .. DSL4, MGMT2, cf. Table 6-1.
LTU_01_PM> ETHERNET ETH1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Statistics of the Ethernet Bridge Port ETH1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
InDiscards : 0
InErrors : 0
InNUcastPkts : 0
InOctets : 0
InUcastPkts : 0
OutDiscards : 0
OutErrors : 0
OutNUcastPkts : 0
OutOctets : 0
OutUcastPkts : 0
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Attributes:
InDiscards
Number of discarded packets during reception
InErrors
Number of errored packets received
InNUcastPkts
Number on non-unicast packet received
InOctets
Number of octets received
InUcastPkts
Number on unicast packets received
OutDiscards
Number of packets discarded during transmission
OutErrors
Number of packets sent with errors
OutNUcastPkts
Number on non-unicast packet sent
OutOctets
Number of octets sent
OutUcastPkts
Number on unicast packets sent