Specifications

W5-Ethernet-Manual.doc
Version 2.0-01
Watson 5 Ethernet
Operating Manual
Revision: 2006-04-27 7-17
7.2 Fault and Maintenance Management FMM
7.2.1 Diagnostic
DIAGNOSTIC
The DIAGNOSTIC (or DIA) command shows the current DSL status. It is available from all
menus by typing DIA.
LTU_01_FMM> DIA
-----------------------------------------+---------------
Diagnostic: SQ Attn PWR Status | Alarms
-----------------------------------------+---------------
DSL span 1 |
STU-C A: 18 0 +13.5 Sync | LKINT
STU-R A: 14 0 +13.5 Sync | LKINT
-----------------------------------------+---------------
DSL span 2 |
STU-C A: 0 0 +13.5 Handshake | LOSW,LKINT
STU-R A: -- -- -- Idle | ---
-----------------------------------------+---------------
DSL span 3 |
STU-C A: 0 0 +13.5 Handshake | LOSW,LKINT
STU-R A: -- -- -- Idle | ---
-----------------------------------------+---------------
DSL span 4 |
STU-C A: 0 0 +13.5 Handshake | LOSW,LKINT
STU-R A: -- -- -- Idle | ---
-----------------------------------------+---------------
On the tabletop the DIA display looks different:
NTU_FMM_REMOTE> DIA
---------------------------------------------+--------------------
Diagnostic: SQ G.826(ES) Attn Status | Alarms
---------------------------------------------+--------------------
NTU-A: +18.5 00000000 +00.00 Sync | LKINT
---------------------------------------------+--------------------
After DIA the screen is continuously updated until the next monitor command is entered.
Attributes:
SQ
Signal Quality
G.826(ES)
G.826 errored seconds (only available on the Watson 5 Ethernet tabletop)
Attn
Link attenuation
PWR
Transmit power (only available on the Watson 5 Ethernet plugin)
Status
Synchronization status
Alarms
List of all active alarms
Note A DSL master displays information both for the local and remote ends (STU-C and STU-R on the
Watson 5 Ethernet plugin, LTU and NTU sides on the Watson 5 Ethernet tabletop).. DSL slaves
display only local information.