Specifications

Watson 5 Ethernet
Operating Manual
W5-Ethernet-Manual.doc
Version 2.0-01
7-4 Revision: 2006-04-27
7.1.2 DSL Configuration (Plugin)
BACKOFF DSL-Port ON | OFF
Set SHDSL Power Back-Off function ON / OFF for a particular DSL port. The default setting is
BACKOFF ON.
CONFIG DSL DSL-Port
The CONFIG command displays the current configuration of a DSL ports of the unit. You can also
use CONFIG DSL-Port as a shortcut.
LTU_01_CM> CONFIG DSL1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local Configuration of SHDSL Span No 1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Master/Slave : Master
Autorestart : Enabled
Power Backoff : Enabled
Payload Rate (max): 2048 kbit/s
Wire Pairs : 1
Line Rate : 2056 kbit/s
Line Code : PAM-16
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
LINERATE DSL-Port n p
Set line rate for a DSL port
Parameters:
DSL-Port
n denotes the number of DSL timeslots to be transmitted (3 ≤ n ≤ 89)
p denotes the linecode: p = 16 for TC-PAM 16, p = 32 for TC-PAM 32. If possible (i.e.
consistent with n) the DSL link will be configured with this desired linecode. If this pa-
rameter is omitted, PAM-16 will be configured when possible and PAM-32 otherwise.
MASTER DSL-Port ON | OFF
Set DSL master mode ON/OFF for a DSL port. On the Watson 5 Ethernet plugin each DSL link can
be configured individually as master or slave.
RESTART DSL-Port ON | OFF
Set Autorestart ON / OFF for a DSL port