Specifications

Watson 5 Ethernet

Operating Manual

W5-Ethernet-Manual.doc

Version 2.0-01

6-4 Revision: 2006-04-27

6.5 Monitor Command Structure

6.5.1 Welcome Screen

After connecting the Terminal/PC the welcome screen is shown with information about the modem

type and Firmware Version, e.g.:

Watson 5 SHDSL Ethernet

ZRH01

Monitor V2.0

+-----------------------+

| Main Menu |

+-----------------------+

1. Performance management (PM)

2. Fault and maintenance management (FMM)

3. Configuration management (CM)

4. Security and remote management (SM)

5. Exit

LTU_01>

To select the desired sub-menu, type the appropriate number.

The available Monitor commands are described in chapter 7.

Notes: ! The Exit command is only available on the plugin if it is installed in a subrack or accessed

via Telnet..

! To address another plugin in the subrack after Exit type %nn (nn = slot number)

6.5.2 Menus

The Monitor menu is structured in the following sub-sets:

Subset Short-form

Performance management PM

Fault and maintenance management FMM

Configuration management CM

Security and remote management SM

Table 6-2: Monitor Command Subsets

6.5.3 Prefixes an Shortcuts

The available commands depend on the submenu currently active.

To access a command from a different submenu the command can be prefixed with the name of

the submenu and a . (Dot), e.g. you can use PM.SHDSL 1 to display the G.826 statistics for

SHDSL link 1 while in the Configuration submenu. If the Performance Management submenu is ac-

tive then SHDSL 1 will display the G.826 statistics and CM.SHDSL 1 will display the configura-

tion of DSL link 1.

Note: Prefixing is only available on the Watson 5 Ethernet plugin.