Specifications

Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
7-24
Revision: 2010-01-20
7.2.13 Management Configuration
The management configuration commands allow you to set up the IP parameters
required for management communications via Telnet or SNMP. They are availa-
ble on the Watson Ethernet plug-in only.
CONFIG MGMT
Displays the current configuration of management IP addresses:
LTU_01_CM> CONFIG MGMT
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Management Configuration
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
IP-Address/Netmask state VID
Front (MGMT1): 192.168.0.16/24 up
Backplane (MGMT2): 127.0.0.1/8 down
Bridge (MGMT3): 192.168.0.1/24 up 4094
Masteragent : ON
MasterIP : 127.0.0.1
RIPv2 : OFF
Trap Destinations : IP-Address Port Version Community
192.168.0.107 162 v1 "traps"
GW IP-Address | DEL
Sets the default gateway.
Parameters:
IP-Address
IP address of the default gateway. Must be on the sub-
net of one of the management ports
DEL
Deletes the currently configured default gateway
MASTERAGENT ON | OFF
Enables (ON) or disables (OFF) the SNMP Agent-X master agent function. Within
one group of modems using Agent-X only ONE modem may be designated Mas-
ter Agent (MASTERAGENT ON), all others must be designated as slave agents
(MASTERAGENT OFF). All slave agents must have the IP address of the master
agent properly configured (with the MASTERIP command). Cf. 8.1.1
MASTERIP IP-Address
Configures the IP address of the Master Agent for those plug-ins that are confi-
gured as Subagents.
Parameter:
IP-Address
IP address of the SNMP Agent-X master
agent.