Specifications

Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
7-12
Revision: 2010-01-20
ETH 1-4
DSL 1-4
MGMT3
- this port is not member of this VLAN
U this port is member of this VLAN, egress frames
will be sent without VLAN tag
T this port is member of this VLAN, egress frames
will be sent with VLAN tag
Ports marked with * do not use VLANs for switching,
but are configured for transparent bridging.
Name
Administrative name of this VLAN
Default VLAN
Default VLAN for this port
Default Prio
Default priority for this port
Doubletagging
Second VLAN tag will be added on egress
Bridgemode
Currently active Bridgemode
DEFAULTVLAN Bridge-Port VLAN-ID Priority
Sets the default VLAN ID and the default priority for untagged packets entering
the plug-in.
Bridge-Port
One of the bridge ports (ETH1 .. ETH4, DSL1 .. DSL4,
MGMT3)
VLAN-ID
VLAN ID to add to all untagged packets entering at this
port (1 .. 4094). Note that the Bridge-Port must also be
member of this VLAN – otherwise all untagged packets
will be discarded.
Priority
Default priority to assign to all untagged packets enter-
ing at this port. Four priority levels (Q4, Q3, Q2, Q1) are
supported. Q4 is the highest priority level.
If a VLAN tag is added to an Ethernet packet on egress
then the priority levels are mapped to IEEE 8021.1p bits
as follows:
Q4 110
Q3 100
Q2 010
Q1 000
DOUBLETAGGING Bridge-Port Direction
Enables/disables double tagging (stacked VLAN operation) on a bridge port, cf.
3.2.5.
Bridge-Port
One of the bridge ports (ETH1 .. ETH4, DSL1 .. DSL4)
Direction
OFF Double tagging is disabled
IN Double VLAN tags are expected on this
port. The first (outer) VLAN tag will be
removed before the packet is