Specifications

Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
7-8
Revision: 2010-01-20
MASTER ON | OFF
Set DSL master mode ON/OFF.
MODE 1 | 2
Select DSL operating mode:
1: 1 pair operation
2: 2 pair operation
RESTART ON | OFF
Set Autorestart ON / OFF.
WETTING ON | OFF
Set wetting current sink ON / OFF.
7.2.4 Ethernet Configuration (Plug-in)
FDX Ethernet-Port mode
Sets duplex mode and speed of an Ethernet port (ETH1 .. ETH4).
Possible values for mode:
AUTO Autonegotiation of parameters
10H 10 MBit/s, half duplex
10F 10 MBit/s, full duplex
100H 100 MBit/s, half duplex
100F 100 MBit/s, full duplex
FLOW Ethernet-Port AUTO | ON | OFF
Ethernet flow control:
AUTO Auto negotiation
ON flow control enabled
OFF flow control disabled
Flow control is implemented with PAUSE frames in full duplex mode and with
backpressure (forced collisions) in half duplex mode.
Note
It is not possible to auto-negotiate flow control without auto-negotiating speed and
duplex modes. Setting FDX to a value different from AUTO and then setting FLOW to
AUTO results in disabling flow control, i. e. has the same effect as FLOW OFF.
MDS Ethernet-Port {Ethernet-Port} [ ON | OFF ]
Enables/disables MAC Defect Signaling for an Ethernet user interface.
MDS Ethernet-Port will display the current state of MDS for a particular inter-
face.
MDS can be controlled for several interfaces with a single command, e.g.