Specifications

Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
Revision: 2010-01-20
7-5
For the Watson Ethernet tabletop modems the DEFAULT values are as follows:
Parameter
DEFAULT 0
DEFAULT 1
DEFAULT 2
SHDSL
Autorestart
Enabled
Enabled
Enabled
Power Backoff
Disabled
Disabled
Disabled
Payload Rate
2048 kbit/s
2304 kbit/s
4608 kbit/s
Operating Mode
1 Pair
1 Pair
2 Pairs
Line Rate
2056 kbit/s
2312 kbit/s
2312 kbit/s
Ethernet
Bit Rate
2048 kbit/s
2304 kbit/s
4608 kbit/s
FDX
Auto
Auto
Auto
Flow
Auto
Auto
Auto
Filtering
On
On
On
Aging Time
300s
Remote
Remote
Scheduling
Strict
Strict
Strict
Ratelimit
Off
Off
Off
Table 7-3: DEFAULT values (tabletop)
Notes
 The default configurations are given for DSL master mode. If the modem is in
DSL slave mode then the DSL linerate is determined by the DSL master and
not by the DEFAULT command.
 The factory setting can be loaded using the DEFAULT 2 command. All DSL
plug-ins and tabletops are delivered with this configuration (plug-ins as DSL
master, tabletops as DSL slave).
 The Master/Slave and Remote Powering settings are not affected by the
DEFAULT command