Specifications

Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
7-2
Revision: 2010-01-20
7.2 Configuration Management CM
7.2.1 General Commands
ADMIN-NAME [ SYSTEM String | DSLx String ]
Defines an administrative name for the system or for one of the DSL spans.
The administrative name of the system is displayed in the Monitor welcome
screen, the administrative names of the DSL spans in the STATUS display. Use
quotes (" ") to enter upper/lowercase administrative names.
The command ADMIN-NAME without parameters will display all currently confi-
gured administrative names.
Note
This command is not available on the Watson Ethernet tabletop modem.
ADMINSTATUS Port UP | DOWN
Set the administrative state of a port.
Parameters:
Port
Port (DSL1 .. DSL4, ETH1 .. ETH4)
UP, DOWN
Administratively enable (UP) or disable (DOWN) the
port.
Ports that are set to DOWN are blocked for traffic and do not create any alarms.
The currently active administrative status is displayed in the STATUS and
STATUS ETHERNET commands.
Notes
 Setting the ADMINSTATUS of a DSL span to DOWN deactivates the DSL physi-
cal layer. Three alarms (SNMP Traps) are generated in this situation: Link
Down alarm, SNR margin alarm and Loop attenuation alarm
 Setting the ADMINSTATUS of an Ethernet port to DOWN deactivates the Ether-
net physical layer. Other devices connected to this port will generate a link in-
tegrity alarm.
 This command is not available on the Watson Ethernet tabletop modem.