Specifications

Watson-Ethernet-Manual.doc
Version 3.3-01
Watson Ethernet
Operating Manual
Revision: 2010-01-20
8-9
8.2.12 Bridge-MIB (RFC 4188)
The Bridge MIB contains basic information about the Ethernet bridge of the Wat-
son Ethernet plug-in card.
Implemented data structures:
 dot1dBase group (Default Context and Card Context)
 dot1dBasePortTable (Default Context and Card Context)
 dot1dStp group (Card Context only)
 dot1dStpPortTable (Card Context only)
 dot1dTp group (Default Context and Card Context)
8.2.13 RSTP-MIB (RFC 4318)
The RSTP MIB controls the Rapid Spanning Tree protocol.
Implemented data structures:
 Additions to the dot1dStp group (Card Context only)
 dot1dStpExtPortTable table (Card Context only)
8.2.14 HDSL2-SHDSL-LINE-MIB (RFC 4319)
The HDSL2-SHDSL Line MIB controls the DSL spans of the Watson Ethernet
plug-in card.
The entire DSL span including both STU-C and STU-R ends is managed by the
MIB which is accessible through the SNMP agent of the master (STU-C) modem.
DSL spans on the STU-C side are accessible in read-only mode through the
SNMP agent of the STU-C..
Each DSL span has a single configuration profile and a single alarm profile. The
profiles have fixed names of the format Span xx Slot yy where yy is the
slot number in the subrack and xx is number of the DSL span (01 up to 04).
The hdsl2ShdslSpanConfWireInterface object can be used to disable a
DSL span by setting it to 0, i. e. defining that the interface contains no wires.
Implemented data structures:
 hdsl2ShdslSpanConfTable
 hdsl2ShdslSpanStatusTable
 hdsl2ShdslInventoryTable
 hdsl2ShdslEndpointCurrTable
 hdsl2ShdslEndpointMaintTable
 hdsl2ShdslUnitMaintTable
 hdsl2ShdslSpanConfProfileTable
 hdsl2ShdslEndpointAlarmConfProfileTable