Use and Care Manual

Schluter
®
-SHOWERPROFILE-WS
Schluter
®
-SHOWERPROFILE-WSK
SHOWERPROFILE-WS can be used in conjunction with tiles that are 5/16" (8 mm) thick or greater.
SHOWERPROFILE-WSK is applied to the floor covering using Schluter
®
-KERDI-FIX, silicone, or similar adhesive. Prior to applying the adhesive, make sure
the surfaces are free from any adhesion-inhibiting substances such as oil or grease.
1
1
2
2
3
3
4
Install the tile covering up to where the profile
will be installed.
Apply a bead of adhesive to the underside
of the profile legs where contact is made
with the floor, and set the profile. Note: End
caps are used when the profile does not
abut a vertical surface. Install end caps with
Schluter
®
-KERDI-FIX, silicone, or a similar
adhesive before installing the profile.
Apply a sufficient amount of thin-set mortar
to this area and to the back of the profile
to achieve full coverage. Press the profile
into the mortar until its surface is flush with
the tile.
Use a suitable cleaning agent to remove
any excess adhesive after placement of the
profile.
Set adjacent rows of tile, leaving a space
of approximately 1/16" - 1/8" (1.5 - 3 mm)
between the profile and tile.
Cut the SHOWERPROFILE-WSL/-WSC
insert to length and insert into the profile.
Cut the SHOWERPROFILE-WSL/-WSC
insert to length and insert into the profile.
32 SHOWER ASSEMBLY — Shower base with Schluter
®
-SHOWER Profiles